Provide your contact details to the exhibitor. Optionally, you may also add a personal message.
Your name, phone number, and e-mail address are subject to the submission of personal data. Messe Düsseldorf GmbH expressly points out that for a data transmission into third countries, for which no adequacy decision of the EU-commission is on hand certifying an adequate level of protection of personal data, it is not ensured that there are appropriate safeguards for the protection of personal data on hand.
Please log in
You must be logged in to send the contact request.
An error has occurred
Please check your internet connection or try again later.
Message has been sent
Your message to the exhibitor was sent successfully.
07 Energy supply / Electrical installations / Electrical appliances
07.19 Solar energy systems
Solar energy systems
Product category: Power packs / Transformers / Converters
Modem & GPS accessory for GX devices The GX GSM is a modem & GPS accessory for our GX range of monitoring products. The GX GSM is a cellular modem; providing a mobile internet for the system and connection to the VRM Portal. It works on 2G and 3G networks.
It includes a built-in GPS receiver. When the optional GPS antenna is installed, the system can be tracked as well as Geo-fenced on the VRM Portal.
Note that many telecom operators are in the process of shutting down their 3G networks. Make sure to consider the replacement product, the GX LTE 4G, as well.
Product category: Rectifiers
AC Current sensor - single phase - max 40A
The AC Current sensor is a simple external current sensor used to measure AC Current, Power (VA) and calculate energy of a PV Inverter connected to the AC input or output of a Multi or Quattro. These values can then be displayed and sent to the VRM-website by the Color Control. The two measurement wires can be connected to the AUX and/or temperature sense input of a Multi or Quattro.
Product category: Battery monitors
The VE.Bus BMS protects each individual cell of a Victron lithium-iron-phosphate (LiFePO4 or LFP) battery. Each individual cell of a LiFePO4 battery must be protected against over voltage, under voltage and over temperature. Victron LiFePO4 batteries have integrated Balancing, Temperature and Voltage control (acronym: BTV) and connect to the VE.Bus BMS with two M8 circular connector cord sets.The BTVs of several batteries can be daisy chained. Please see our LiFePO4 battery documentation for details. The BMS will: Shut down or disconnect loads in case of imminent cell under voltage. Reduce charge current in case of imminent cell overvoltage or over temperature (VE.Bus products only, see below). Shut down or disconnect battery chargers in case of imminent cell overvoltage or over temperature.
Product category: Battery monitors
With Bluetooth built-in, the BMV Smart is ready for the Internet of Things (IoT) era. With Bluetooth being implemented in most other Victron Energy products, wireless communication between products will simplify system installation and enhance performance.
Models: Bluetooth built-in
Product category: Battery chargers
Adaptive 4-stage charge characteristic: bulk - absorption - float - storage. Two full rated outputs and one 4 Amp output. Universal input 90-265V, 50/60Hz. The Phoenix charger features a microprocessor controlled adaptive battery management system that can be pre-set to suit different types of batteries. The adaptive feature will automatically optimise the charge process relative to the way the battery is being used.