Manage stand orders
Select Option

Wurmi Entwicklung und Vertrieb Ernst-Otto Göhre Neuheiten für Camping und Freizeit

Bullauer Str. 37, 64711 Erbach
Germany
Telephone +49 6062 4639, +49 160 90317610
t.goehre@wurmi.de

Submit your contact details

Provide your contact details to the exhibitor. Optionally, you may also add a personal message.

Please log in

You must be logged in to send the contact request.

An error has occurred

Please check your internet connection or try again later.

Message has been sent

Your message to the exhibitor was sent successfully.

Hall map

CARAVAN SALON 2021 hall map (Hall 3): stand E31

Fairground map

CARAVAN SALON 2021 fairground map: Hall 3

Our products

Product category: Tentpegs

Pavilion fixing set

(Wurmi ground anchoring for pavilions of various manufacturers, folding pavilions, garden tents, party tents, greenhouses, etc.)

With four earth sand worms and four hook pin plates as well as a screw-in pin (all in a practical storage bag), you can make your pavilion windproof.

Pavilions are mostly equipped with feet with an 8mm hole. If the fixing hole is smaller then simply drill out to 8mm. For ease of use Wurmi has developed the hook pin plate, which meets the special requirements of an earth fixing. Due to the sophisticated screw geometry, Wurmi holds on tension in any direction.


The hook pin plate is inserted with the pin facing downwards through the fastening hole in the support leg and pressed against the ground. The geometry of the earth worm and hook pin plate means that in very hard and stony ground, it is only screwed in until the earth worm is firmly seated at its own discretion and at least one full thread of the screw-in peg presses against the hook pin plate. If the ground is soft, screw through until the screw head is seated. The lug on the hook pin plate is for storm bracing.

Contents: 4 x earth sandworm, 4 x hook pin plate, insertion pin and bag.

More Less

Product category: Tentpegs

Starter set awning with hook clips

Our starter set for awnings and others.....
Attention from now on with optimized screw head for the new click nut

Our starter set is equipped with a proven hook clip,
which, with its hook open at the bottom, hooks into lugs, tensioning lines and much more when screwed in.

From now on screwing in Wurmi Standard and Trekking will be even easier.
By changing the screw adapter and adapting the 17mm screw head
you can now click the screw peg onto the screw adapter.

The Wurmi holds loosely in the click nut without falling out.
This leaves your second hand free to hold tent flaps, guy lines, etc. while screwing it in.
Plus, it's easier to unscrew:
You simply snap the click-nut onto the screw head of the Wurmi,
go up with the unscrewing speed until the Wurmi is unscrewed.
Then simply click out of the click-nut with your free hand.
The click nut is included in the starter set and fits all 17mm screw heads from Wurmis,
which are ordered from 01.08.2013 in our shop.

Our new starter set awning with hook clip includes:
  • 40 standard worms
  • Hand screw adapter
  • 40 hook clips
  • Wurmi bag
Click nutIf the ground is very hard or frozen, you should pre-drill with an 8mm masonry bit.

Our wormis are made of glass fibre reinforced UV resistant polyamide,
benefit from 15 years of quality, 15 years of experience and continuous improvement.

More Less

Product category: Tentpegs

Awning set Womo with hook clips

Our new awning set Womo 2010 is equipped with 2x Multifix awning brackets
equipped. These fit universally on Omnistor and Fiamma awning feet.
Other poles (e.g. plate foot) can also be attached to the floor with it.

For this purpose the awning set has 6 standard wormis with our new hook clip
in this case, the hook clip can be used as a grid for the standard worms
serve, if these do not go completely into the ground. Of course the hook-
clips can also be used with the standard wormies, e.g. to attach additional
Tensioning lines for the awning or safari room.

The distinctive geometry, with the hook open at the bottom, has proved itself
proven and is only one advantage over competitors. Because thereby
You can attach lugs, retaining rings, tensioning lines, etc. as soon as you screw them in
and screw in in one operation with the Wurmi.

6 trekking worms are also included, so that you can fix the Multifix on extremely hard and
can be fastened to solid ground.
The bag and the adapters for hand and battery screws are also not missing!
In detail, our awning set Womo 2010 with hook clip includes:

  • 2x Multifix plate with hooks (for Omnistor & Fiamma awnings)
  • Machine screw adapter
  • Hand screw adapter
  • 6 standard worms
  • 6 trekking worms (for extremely hard floors)
  • 6 hook clips
  • Wurmi bag
This Womo awning set leaves nothing to be desired!

Our Wurmis are made of glass fibre reinforced UV resistant polyamide,
benefit from 20 years of quality, 20 years of experience and continuous improvement.

More Less

Product category: Tentpegs

Kombifix - Set XL with bag

Here is our new hook pin plate as a complete set for your awning, gazebo, etc.

Contents:
2x hook pin plate
2x Earth-Sandworm
1x worm pocket
2x standard worms
2x hook clips
1x hand screw adapter for standard worms
1x screw-in pin for earth sandworm

More Less

Product category: Tentpegs

Wurmi Standard 10 pieces with hook clips

Standard worm with hook clip

Attention from now on with optimized screw head for the new click-nut

The 18 cm long standard Wurmi with the white clip has already been a universal ground anchorage for tents, guy lines etc. With our new hook clip it is even more efficient and better applicable. It can be screwed in easily with our hand screw adapter or with a cordless screwdriver and the screw adapter or with the new click nut from our assortment in grounds of different condition.

If the ground is very hard or frozen, you should pre-drill with an 8mm masonry drill bit.

Our wormis and also this product are made of glass-fibre reinforced polyamide
Made of UV resistant polyamide, benefit from 15 years of quality,
15 years of experience and continuous improvement.our new hook clip:
The distinctive geometry, with a hook open at the bottom has proven itself and is only one of the huge advantages over competitors. This allows you to automatically hook in lugs, retaining rings, tensioning lines, etc. and screw them in with the Wurmi in a single operation. The new hook clip is also ideally suited for tensioning storm lines. However, please remember not to over-tension your tent.

You can also use the hook clip as a grid for their Multifix attachment,
if the ground should ever be too hard for the standard worm to go in.

The new hook clip is stronger and more versatile than its predecessor, we claim
even the strongest hook in its class.

More Less

Product category: Tentpegs

Trekking Wormi 20 pieces

The Trekking Wurmi

Attention from now on with optimized screw head for the new click nut

The smaller version of the Wurmi is intended for those who want to travel with a particularly light tent
people who want to travel light (backpackers, etc.)-

The Trekking-Wurmi is only 11 cm long and extremely light. It can be used for small tents,
like e.g. igloos, but especially fits through the 8 mm eyelets
the tent skirts.
The Trekking-Wurmi can be screwed in either with the hand screwdriver or with a rechargeable
the Trekking-Wurmi can be screwed in with a screwdriver and the screw adapter or the new Click-Nut from our range.
If the ground is hard or frozen, you can pre-drill with a 6 mm drill.

The Trekking-Wurmi is available in sets of 10 or 20.

Our screw peg "Trekking-Wurmi" is made of UV-resistant, glass-fibre reinforced polyamide
reinforced polyamide and therefore fulfils almost all requirements in camping
and leisure. Benefit from 10 years quality, 10 years experience
and constant improvement.

More Less

Product category: Tentpegs

Earth sandworm single 32cm length

The 32 cm long Earth Sandworm is a larger version of the Wormis and is also made of
Is made of UV-resistant, glass-fibre reinforced polyamide. It is particularly suitable for
sandy and soft soils and holds there even during storms. The Earth Sandworm
can be easily screwed in with a 24 mm nut or a ring or open-end wrench
screwing in. However, a screwdriver or a pin will also do.

Applications the sandworm is used for fixing storm bracing for
Awnings, garden furniture, flagpoles, swings and slides or small
Sports planes.

The head of the earth sandworm is exta larger (24mm) than our standard wormis,
so that you can also work with a lever (e.g. screwdriver).

More Less

Product category: Tentpegs

Superworm ( aluminium ) with shackle 15mm

The entire length of the aluminium Superworm can be screwed into almost any soil. Due to the sophisticated thread geometry with 8 flanks and increasing diameter up to 27mm as well as the large 24mm screw head, it is possible to use strong insertion tools with the necessary power transmission to screw in the 30cm long aluminium Superworm with its entire length. A through hole (8mm diameter) in the screw head offers an additional screw-in alternative, because the Superworm can be screwed in with a screwdriver or a strong pin. Once screwed in, objects can also be anchored and secured by means of this through hole. So that holds whatever you want to fasten.

Following the high strength requirements, the aluminium superworm is supplemented by a versatile metal shackle. The shackle can be attached both before and after screwing in. This makes it possible to attach snap hooks to the Superworm. The shackle is also available in stainless steel on request.

More Less

Product category: Tentpegs

Storm protection set aluminium

Wurmi storm protection for awnings and awnings

The Wurmi storm protection set consists of

  • 2x Profiworm Aluminium
  • 2x steel shackle 15mm Attention: This shackle is only suitable for underhead mounting!
  • 2x HT storm lines for keder rail
  • 1x crank handle
With our proven Profiwurm and the HT storm line, we now offer the perfect solution for securing your awning or awning!

With the HT storm cord, only 2-3 guy lines are necessary - as we offer a unique combination of tent cord & storm strap here.
The keder is simply pushed into the keder rail - and you can tension straight to the front.
Our keder adapter fits all standard keder rails with at least 5.5 mm - do not use for 9 mm rails!
The length to the screw peg, is adjusted directly on the 120 kg loadable plug-in lock. You can then additionally fix the length setting using a loose loop with strap stopper - so everything looks tidy.

- Individual securing of tent poles and awning arms
- no additional guy line necessary
- 1-click emergency release lock - even under load
- at least 120 kg strength per storm strap
- Spring element with technically limited spring travel (unintentional unhooking impossible)
- made of UV-stable POLYESTER webbing

The advantages of our proven Profiworm:

The aluminium Profiworm can be screwed into almost any ground with its whole length. Due to the sophisticated thread geometry with 8 flanks and increasing diameter up to 27mm as well as the large 24mm screw head, it is possible to use strong screwing-in tools with the necessary power transmission to screw in the 30cm long aluminium Profiworm with its entire length. A through hole (8mm diameter) in the screw head offers additional screw-in alternatives, because the Profiworm can also be screwed in with a screwdriver or a strong pin. Once screwed in, objects can also be anchored and secured by means of this through hole. So that whatever you want to fasten will hold.

More Less

Product category: Tentpegs

10 Waterstop Clips and 10 Wurmi Standard 18cm

Wurmi has developed the water stop clip so that your tent floor in the awning remains dry.

The water stop clip is simply clipped onto the standard Wurmi 18cm.

To do this, the Wurmi is screwed 2/3 into the ground and the sheeting is raised in front of the screw peg and locked in place with the water stop clip by applying a little pressure.

You can also screw in the Wurmi with clip first and then clamp in the foil.

The water that runs towards your awning should be diverted and diverted by this.

Remember that large amounts of water from the tent roof and from the neighbouring tent can lead to short-term flooding.
When buying a new foil, remember that it should be 20-30cm larger so that it can be raised.
It's a nice feeling to be dry.

More Less

About us

Company portrait

ABOUT WURMI
Quality control from German production.
Trust begins with transparency.

In 1966, a patent application was filed for the first screw peg. Independently of this, Ernst-Otto Göhre also had the idea for a screw ring for camping in 1998. As a passionate camper, he has been personally familiar with the variants with tents, caravans and motor homes for over 45 years. With every camping holiday he receives further suggestions, which he then checks for practical suitability. Thus, in the course of time, a single screw peg became a complete fastening system. The WurmiSystem quickly gained popularity. Useful system components for large animal owners, garden designers, event managers and aircraft owners followed.

The company's philosophy includes active customer support and the development of customer-specific products. This is how, among other things, a variant of the ErdSandWurmi helped to secure snow supplies for the Winter Olympics in Sochi.

After 19 years of continuous improvement in material formulation, plastic injection processes and optimisation of shaping, our products stand for the highest quality. Of course, attention has also been paid to maximum UV resistance.

Wurmi products are one hundred percent manufactured in Germany. German industrial masters monitor the production process and guarantee exact and consistent production parameters. Furthermore, Wurmi products are subject to quality control and comply with the seal of quality in every respect.